TP Series Cooling towers cool recirculated fluids that support industrial process cooling applications.
Cooling Towers are typically used to supply cooling temperatures between 5°F to 10°F above the ambient wet bulb conditions.
Cooling Towers provide cooling water to multiple processes, including hydraulics, chiller condensers, temperature control units and other equipment.
Temptek offers cooling towers in capacities from 45 to 540 tons in single and expanded cell systems.
Capacity : 105 tons
Flow Rate : 315 GPM
Direct Drive Fan
Quantity : 1
RPM : 1,170
CFM : 25,465
Quantity : 1
HP : 10
Full Load Amperage (3)
230/3/60 : 14.2
460/3/60 : 12.1
575/3/60 : 10
Connection Sizes (5)
To Tower : 4"
From Tower : 6"
Height : 138"
Width : 84"
Depth : 73"
Dry : 1,320 lbs
Operating : lbs
Shipping : 1,600 lbs
1. Since product innovation and improvement is our constant goal, all features and specifications are subject to change with notice or liability. Selection of certain optional features may change listed specifications.
2. Cooling water from 95°F to 85°F at 3 gpm per ton and 78°F web bulb temperature.
3. Full load amps are higher than run load amps and must be used for sizing disconnects and supply wiring. Not for construction. Consult factory for power requirements of unit as configured and on selected options.
4. Consult factory for 50HZ operation.
5. When used with remote sump consult factory for connection size when the base of the tower will be used as the reservoir.
Cooling Tower Design
Single cell design
Total non-ferrous construction materials
Single inlet and drain connections
Counter-flow air movement
Structural galvanized steel base
Air foil shaped blades for increased air flow
Blades are made of a glass fiber reinforced polymer
Blades are factory set at best angle for maximum air movement
Direct drive mechanics
Non-ferrous PVC 'cross' construction
Computer designed spray pattern
Large orifice spray heads
PVC spray heads
Drift eliminator prevents over spray and water loss
eamless gasket sealing
Allows for inspection on cell interior and replacement of wet deck
Stacked honeycomb pattern maximizes water and air flows for greater cooling efficiency
High strength fiberglass molding
1/2" of structural thickness in reinforced areas
UV stabilized coating
Acrylic adhesive bonding between shell halves
Mounted on a stainless steel frame
Supported on reinforced fiberglass shell area
Mounted to shell with stainless steel fasteners
Easily removed for cleaning
Vertical orientation to eliminate water loss
Directs air flow for even distribution through wet deck
Helps prevent air-born debris from entering cell
10 year shell warranty
5 year motor/fan warranty
Fan Starter Kit
Motor start contactor
Motor overload relay
Nema 1 enclosure
Basin Float Valve
Mechanical float and valve
1/2" supply connection
Factory or field installed
10' Tower Stand
10' corner post design with cross bracing
Ladder and railing attachments
2 pages Color 236 KB
38 pages B/W 416 KB
T105P cooling tower. Model shown is typical. Unit appearance may change depending on options and specifications.
Temptek, Inc. 525 East Stop 18 Road, Greenwood, IN 46142 Phone: 317-887-6352 Fax: 317-881-1277
Product innovation and improvement is our constant goal. All features and specifications are subject to change without notice or liability. Products are
assembled in the United States of America. Site Map
2019 TEMPTEK, INC